Drag chain is a device to protect cables and wires, which can prevent the back and forth movement of wires and cables and avoid abrasion. However, the cable that cannot be completely wrapped in the mop by industrial technology will not move, so how to reduce...

Linear motor is mainly linear motor, which is a transmission device that directly converts electrical energy into linear motion mechanical energy without any intermediate conversion mechanism. It is a new technology with new principles and theories in the fi...

Thermal conductive gasket and thermal conductive silicone grease are both materials used for heat conduction and heat dissipation. In the current market, these two kinds of heat conduction materials have been applied. However, due to their different manufac...

They have all used the heat transfer adhesive. It has strong connectivity, and it is difficult to remove it after it is stuck on. Many friends do not know the correct removal method of the heat transfer adhesive. When removing the heat transfer adhesive, t...

Many customers will ask us, there are many kinds of conductive adhesive, how to choose? The following Jingzheng Intelligent Manufacturing Technology makes up to tell you that when we buy conductive adhesive, we need to understand three things first:...

The thermal problem of the battery module affects the safety, performance and efficacy, service life and other key factors of the battery. Too high or too low a temperature will affect the battery pack. Therefore, it is necessary to control its temperature ...

UV adhesive, also known as UV curable adhesive and shadowless adhesive, is an adhesive that must be cured by ultraviolet light. It is used for bonding and fixing transparent articles, with high curing speed. It can be used for bonding and fixing of vario...

With the rapid development of the machine tool industry, the demand for its parts is also increasing. While increasing, we should pay special attention to the quality problem. This article mainly introduces which linear guide is more suitable for machine to...

Like many other types of sensors, torque sensors use strain technology for measurement. The sensor is usually a metal elastomer on which a strain gauge (SG) is mounted. The strain gauge is firmly attached to the elastomer....

Common pneumatic components: air compressor, aftercooler, air receiver, dryer, water separation filter, oil mist collector, muffler, cylinder, pressure control valve (pressure reducing valve, sequence valve and safety valve), flow control valve (throttle valv...

Take the single piston rod double acting cylinder most commonly used in the pneumatic system as an example. The typical structure of the cylinder is shown in the figure below. The utility model is composed of a cylinder barrel, a piston, a piston rod, a fro...

The solenoid valve is composed of solenoid coil and magnetic core, and is a valve body containing one or several holes. When the coil is powered on or off, the operation of the magnetic core will cause the fluid to pass through the valve body or be cut off t...

Thermal conductive silica gel sheet is a gap filled thermal conductive material, which is mainly used for the transfer interface between electronic equipment and heat sink or product shell. It has good viscosity, flexibility, compressibility and excellent th...

The so-called gas sensor refers to the sensor used to detect whether there is a specific gas in a certain area or to continuously measure the concentration of gas components. With the continuous development of society, gas sensors play more and more roles. I...

In recent years, with the continuous increase of environmental governance, all key industrial enterprises in China have basically installed over standard alarm facilities. The gas alarm controller, as a single point gas monitoring device, is mainly used in ...

Thermal conductive interface material is a kind of polymer composite material with polymer as matrix and thermal conductive powder as filler. With good thermal and mechanical properties, it is widely used between the heat source and the radiator in electroni...

At present, the rugged and commercialized LCD displays meet too many daily applications, and many structural materials used for LED displays are also used in the assembly process of LCD displays. Although some led backlights have many requirements f...